Twin Tower

TWIN TOWER ENGINEERING, INC.		Regenerative Desiccant Air Dryers Using Pressure Swing Adsorption (PSA) technology, the Twin Tower Engineering heatless regenerative air dryers are designed to maximize the efficiency of the drying process. Ultra-Dry compressed air dew points to better than -100°F can be achieved.
Some Typical Dry Compressed Air Applications:
• Ozone Generators • Air Bearings • Vortex Tubes • Antenna Pressurization • Waveguide Drying • Air Brushing • Gas Chromatographs • Robotic Machinery • Car Wash Controls • Graphic Printers • Air Turbines • Air Operated Pumps • Environmental Chambers	• Pneumatic Automation Systems • Medical Air Compressors • Dental Air Compressors • Bus Door & Locking Systems • CEMS Systems • FTIR Spectrometers • NMR Spectrometer • Laboratory Analyzers • Dry Sprinkler Systems • Outdoor HVAC Controls • Electronic Chip Testing • Dry Nitrogen Replacement

		MDH Series for flows from 0.1 to 3.2scfm Ultra-small air dryers can be used with fractional horsepower air compressors. These units are heatless regenerative desiccant air dryers designed to produce low dew points. Extremely small footprint allows for packaging inside equipment cabinets or at point-of-use. Click here for MDH Series brochure.

		VSA Series for flows from 2.8-12 scfm Economical and compact, these heatless desiccant compressed air dryers provide low dew points to -100°F ADP (atmospheric dew point). This proven "no-frills" design uses Pressure Swing Adsorption (PSA) technology and will provide years of trouble-free service. Click here for VSA Series brochure.

		HR Series for flows from 3-50 scfm Using Pressure Swing Adsorption (PSA) technology, the Twin Tower Engineering regenerative air dryers are designed to maximize the efficiency of the drying process. Ultra-Dry compressed air dew points of -40°F to better than -100°F can be achieved. Click here for HR Series brochure.

		High Efficiency Filter Packages All air dryers require filtered air to protect them from dirt, scale, oil liquid and aerosols, and liquid water in a compressed air system. These contaminants can cause malfunction or loss of drying efficiency. These sets of filters are matched to our HR-Series and VSA-Series compressed air dryer models in flow and performance. Each set includes two prefilters to protect the air dryer from liquid water and oil, one afterfilter to protect downstream components, and wall mounting brackets. Click here for Filter Package brochure.

		Color Change Moisture Indicators and Electronic Humidity Alarms Twin Tower Engineering offers moisture indicators and humidity alarms to provide an inexpensive way to monitor a dry compressed air system. The moisture indicator or humidity alarm can be installed anywhere in the system, after the air dryer or at point-of-use. The Moisture indicator shows a color change (blue to pink) when moisture levels rise. The electronic humidity alarm provides a local red light and a dry-contact closure when wet air is detected. The dry-contact alarm signal can be monitored at a remote location, wired to energize a horn or buzzer, and/or operate a shut-off solenoid valve to stop the flow of wet compressed air. The alarm operates on 115 volt AC power and is enclosed in a NEMA 4 rated box. Click here for Moisture Indicator brochure. Click here for Humidity Alarm brochure.

Air & Vacuum Process, Inc.
14090 FM 2920 Suite G-537
Tomball, TX 77377
Toll Free: 866-660-0208
Local: 281-866-9700
Fax: 281-866-9717

E-mail